CDM Gear Roc-12 Shotgun Light Mount & Barrel Clamp - CDM-ROC-12

ROC-12 Barrel Clamp With Built In Rail Mounts

The CDM Gear ROC-12 series of light mounts is a US made aluminum railed barrel clamp that is used to support factory and aftermarket 1″ diameter magazine tubes, and extensions, while providing low profile mounting rails on the left and right side for rail mountable lights and accessories. The rail and clamp half are manufactured as one piece from aluminum and precision CNC machined to size. All threaded holes are press formed into the mount for hardness. The entire mount is then machine finished to soften round edges before we type III mil spec hard coat anodized for durability. Fingers at the top of the clamp allow for use with a barrel rib and/or compensation ports, as well as slight barrel taper, while a solid surface on the bottom accepts our 3M no slip grip pads to reduce movement under recoil. Just 2 socket head cap screws work opposite each other to hold the clamp in place and are included along with a wrench and our 3M no slip grip pads for the magazine tube. The mount requires 1 1/2″ of mounting surface without interference from a heat shield. Will not work with heavy walled barrels or magazine tubes larger than 1″.

Fits Remington 870, 1100, 1187, Benelli M1/M2/M4/M104, Mossberg 500 7 shot, 590, Winchester 1200, 1300, SXP. Must have 1.25″ of available space on a 1″ magazine tube. Will not work on Benelli M3, SuperNova, Mossberg 590A1 or 930 SPX. May not fit older Remington 870 products with greater than a 1/4″ spacing between the barrel and magazine tube.

NOTE: (will not fit Nordic Components or larger magazine tubes). Sling swivel, light or other accessories are not included.