-100x100w.png "Pike Arms Canada")
This is a
direct replacement for your OEM trigger guard. Simply remove your trigger guard
from your shotgun. Strip off all the parts from the original and install them
on our part.
Our part is made of high quality American milled aluminum. It is finished in a
gunmetal grey hard anodize and laser marked. We do all of the machining in our
shop and the metal finishing is sourced locally.
The patent-pending design has a large scallop on the front to facilitate
loading. It was developed in response to the double and quad loading techniques
that have been developing in the 3 gun world over the last several years.
However, in testing, it was found that the feature dramatically improves single
shell loading as well. It almost doubles the effective loading port area.
The A&S
Benelli M4 Enhanced Trigger Guards fits Breda B12i guns, however the factory
Breda trigger is slightly too long and drags on the bottom of the trigger
guard. The factory Breda trigger needs between .015”-.030” removed from the
circled end to function properly. Briley can perform this service while
installing a trigger guard ($45 additional), or you can personally modify your
trigger. If using a Briley Match Trigger the trigger will fit as normal and no
additional work is needed.
USA made and
counts towards 922(R) Compliance
Does not fit 12 gauge: SBE, SuperSport or any Benelli with trigger pin at the
rear of the receiver.
Does not fit 20 or 28 gauge Benelli shotguns.
